Quote from bob on March 28, 2019, 1:49 pmback to working the downstairs.... checked my setup to make sure all the rain had not made the floor distort... everything checked in perfectly.... bench checked the laser. it was good for 1/32 in 15'. (special note.... you have to really check these because a new laser can be out a lot …. I bought several to find this one)
This project is unique in that it is being built by the numbers, x/y coordinates /Datum of the Porsche Workshop drawings.
usually a car is repaired by fitting the new fender to the damaged car etc..... or placed on a fixture with sets of hardware,,,,
SO.... shot the threshold and both sides of the mock up were elevation 33.
mocked up the front slam panel, PP230P, and got elevation 231 on both sides....
I will now proceed to mock up repair parts inner fender repair panel PP236a/r and inner fender bottom/middle repair panels PP236cr/l ….